LSafe.gif (6682 bytes)RSafe.gif (5336 bytes)

Paint Removers  Wood Preservatives  Medical Supplies   Concrete Materials
Safety Sheets  Contact Us  How to Buy  Visit The Furniture Guy  History  Home

 

BACK

EFFECTIVE DATE: 12/01/94

SECTION 1 - PRODUCT IDENTIFICATION

Product Name: TARDUS

Chemical Name: Concrete Surface Retarder

Formula: Proprietary

Chemical Family: Aqueous Mixture

CAS Number #: None for mix

Emergency #: 1-800-535-5053


SECTION 2 - COMPONENTS

INGREDIENT   OSHA HAZARD
Proprietary Mixture   Eye irritant

 

SECTION 3 - PHYSICAL DATA

Boiling Point For product 200 Deg F
Vapor Pressure For product 760 mm/Hg @ 20 Deg C
Specific Vapor Density   Not Available
Specific Gravity H20=1 1.2
Percent Volatile   70
Evaporation Rate n-Bu Acetate=1 1

Appearance & Odor Reddish Liquid


SECTION
4 - FIRE AND EXPLOSION INFORMATION

FLASHPOINT: None

EXTINGUISHING MEDIA: Not applicable.

HAZARDOUS DECOMPOSITION PRODUCTS: Not applicable.

FIREFIGHTING PROCEDURES: Not applicable.

SPECIAL FIRE AND EXPLOSION HAZARDS: Not applicable.


SECTION 5 - HEALTH HAZARD DATA

EFFECTS OF OVEREXPOSURE

EYES:
Irritating, and may injure eye tissue if not removed promptly.

SKIN:
Low order of toxicity.

INHALATION:
Negligible hazard at ambient temperature (-18 to 38 Deg C; 0 to 100 Deg F).

INGESTION:
Minimal toxicity.

FIRST AID

EYE CONTACT:
Flush eyes with large amounts of water until irritation subsides If irritation persists, get medical attention.

SKIN CONTACT:
Flush with large amounts of water; use soap if available. Remove grossly contaminated clothing, including shoes, and launder before reuse.

INHALATION:
Using proper respiratory protection, immediately remove the affected victim from exposure. Administer artificial respiration if breathing is stopped. Keep at rest. Call for prompt medical attention.

INGESTION:
First aid is normally not required.


SECTION 6 - REACTIVITY DATA

HAZARDOUS POLYMERIZATION:
Will not occur

STABILITY:
Stable

INCOMPATIBILITY:
None.


SECTION 7 - SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED

Contain spill and absorb with inert material. Place in DOT drum.

WASTE DISPOSAL METHOD:
Dispose of all waste in accordance with Federal, State and Local agencies by a state approved waste hauler.


SECTION 8 - SPECIAL PROTECTION INFORMATION


PERSONAL PROTECTION:

For open systems where contact is likely, wear long sleeves, chemical resistant gloves, and chemical goggles. Where contact may occur, wear safety glasses with side shields. Where overexposure by inhalation may occur and engineering, work practice or other means of exposure reduction are not adequate, approved respirators may be necessary.

VENTILATION:
Maintain ambient concentrations below recommended exposure limits.


SECTION 9 - SPECIAL PRECAUTIONS OR OTHER COMMENTS

OTHER HANDLING & STORAGE CONDITIONS:
Store at 40 Deg F to 180 Deg F to maintain quality. Avoid freezing product.

PROTECT FROM FREEZING:
Keep containers tightly closed to prevent formation of dried film. If film does form, product should be filtered before use.

The information accumulated herein is believed to be accurate but is not warranted to be whether originating with Green's Products Company or not.

 

[PAINT REMOVERS]  [WOOD PRESERVATIVES]  [MEDICAL SUPPLIES]   [CONCRETE MATERIALS]
[SAFETY SHEETS]  [CONTACT US]  [HOW TO BUY]  [VISIT THE FURNITURE GUY]  [HOME]